Wenzhou billboard production and installation process:

Picture construction and lighting: In addition to the naked plate and the bottom bracket, the three-sided billboard also touches the picture construction and lighting.

1. Bottom bracket: The three-side flip billboard should be placed on the wall of a stable metal bracket or building. The base bracket is built by the buyer's own plan, and it is necessary to calculate the harsh base compression and wind strength of the support, so that it can reach the pressure request of the metal bracket and the weight of the three-sided billboard on the base, and reach the wind resistance request of the local wind. If the three-sided flip billboard is placed on the metal bracket, the back of the bracket should be completely blocked with iron plates to avoid dark light transmission and affect the picture results.

Wenzhou billboard manufacturers talk about how to make billboards

Request for the construction accuracy of the base support:

a. Beam request degree, column request vertical.

b. For the purpose of the screen length, the straightness is less than 10 mm, and for the purpose of the screen height, the upper and lower beams are less than 20 mm. The construction strength of the base bracket is required: the lower beam is a load-bearing layout that supports the weight of the triple flip billboard, and the elastic deformation occurring at each point adjacent to the triple flip billboard shall not exceed 2 mm.

Blister luminous letters

Special note: Base support plan, construction, should be looking for amateur skilled staff with grade talent plan, construction.

2. Placement pace: According to the size of the request, first install the upper and lower outer frame (request the inner Angle of the outer frame is 90 degrees) firmly on the bracket, and then the left and right outer frame is adjacent to the upper and lower frame, and finally install the triangular prism picture.

3. Switch the screen: close the power supply at the beginning, lift the triangular prism up 20 mm, and then move the triangular prism horizontally from the bottom, the upper end of the triangular prism will take the initiative to leave.

The picture is usually made of immediate paste with back glue, which can be longitudinally cut into 140 mm wide, numbered, and affixed to the triangular prism in order (in the process of disassembly and transfer, the triangular prism can not be violently impacted, preventing the permanent deformation of the triangular prism, and the deformed triangular prism will cause the operation to hinder).